Wind Mill Slatwall

"4 Way" Display Fixture Wings Installation

 

4way tools and hardware

Tools and Hardware Required (supplied with base kit hardware)

(1) Allen Wrench
(12) Confirmat Screws
(12) Screw Caps

Tools - Optional
Rubber mallet

4way kit contents

4 Way Wing Kit Contents

A. (4) Wing Panels
B. (1) Assembly Instructions

4way dowel pin

Step 1 (Assemble the 4 Way display panels onto base)

Make sure the 4 wooden dowel pins are inserted into the base top.
*Tip - the rubber mallet can be used to seat the wooden dowel pins fully.

4way wing

4way 2 wings

Step 2 (Assemble 4 Way display panels onto base)

Start by installing two panels together onto the dowel pins. Locate the holes on the bottoms of the panels and set them onto the pins. Attach the panels together with the confirmat screws. *Note: It is helpful to use two people at this step.

Once the first two panels are together, you can install the remaining panels to complete the unit.

*Tip - Do not fully tighten all the screws until all the panels are in place. Once all the wing panels are together and in place, final tighten the screws.

4 way complete4way deco cap

Step 3 (Adhere the decorative screw caps to cover the screw heads)

Peel the decorative screw caps to expose the sticky back, and carefully center and cover the screw heads.

For more information about the fixture program, or to become a distributor - call Karen Mueller at 920.467.9313. Send Karen an email at - karen@Wind Millslatwall.com




© 2015 Wind Mill Slatwall™ Products
200 Balsam Road   |   Sheboygan Falls, WI 53085   |   800.548.7528